The
IPv4 Settings
tab allows you to configure the method used to connect to a network, to enter an
IP address, DNS and route information as required.
4.
To assign the IP address manually, select the Method option
Manual
.
5.
In the
Addresses
section, click the
Add
button.
6.
Enter the new IP Address, Netmask and IP address of the Gateway, then click
Save
.
After running the script, you will need to reboot. See section "First Install" on page 1.
Manually Changing the Server's Hostname
To change the server's hostname after it was set during installation, proceed as follows:
1.
Open a terminal window.
2.
Type the following command:
sudo nmtui
INSTALLATION AND CONFIGURATION MANUAL
Xeebra | 5. Configuration |
17
