INSTALLATION AND CONFIGURATION MANUAL
GXG400 – GXG410
30
G-BlackA
G-BlackA
controls the Green-Black of channel A. The control range
is between –128bits and 127 bits in steps of 1 bit The
default setting is 0 bit.
B-BlackA
B-BlackA
controls the Blue-Black of channel A. The control range is
between –128bits and 127 bits in steps of 1 bit The
default setting is 0 bit.
Note
This function isn’t currently not accessible but will be enabled in a
software release in the future.
Y_Gain
This function isn’t currently not accessible but will be enabled in a
software release in the future.
C_Gain
This function isn’t currently not accessible but will be enabled in a
software release in the future.
EMBEDDER
Audio_CtrlA
With this item you select how audio proc amp presets for Channel A
are controlled: Manually (
Manual
) or via GPI-triggers (
GPI
,
GPI-A
,
GPI-B
or
GPI-C
). Default is
Manual
Audio_Prst_ActA
With this item you can manually change the currently active preset of
channel. Can be any preset between 1 and 16. By default it is set to 1.
All menu settings that are preceded with a ‘
#Ins
’-prefix are part of
the preset.
Audio_Prst_EditA
Here you can select which of the 16 selectable presets you want to edit
for Channel A. Changing this will not change the active preset, unless
the currently active preset is the same you are going to edit. All menu
settings that are preceded with a ‘
#Ins
’-prefix are part of the preset.
#Silence-TimeA
If the embedded audio contains silence, this can be reported by the
card. This setting allows you to determine how many seconds it takes
before the card reports the silence. This setting can be set in a range
from 1 sec to 255 sec. The default setting is 10sec.
#Silence-LevelA
With this setting you set a loudness threshold for the silence detection.
Can be set between -100 and -20 dBFS. When the audio goes below
this value, a silence alert is triggered. Default is
-60dBFS.