Evoqua V10K, Руководство пользователя

Страница: 25 / 150

WT.025.100.001.UA.IM.0614
V10K V-NOTCH CHLORINATOR
12
EVOQUA W3T109612
WARNING: THIS CONTROL UNIT IS DESIGNED TO OPERATE UNDER VACU-
UM ONLY. TO AVOID POSSIBLE SEVERE PERSONAL INJURY OR EQUIPMENT
DAMAGE, DO NOT CONNECT TO A SOURCE OF GAS UNDER PRESSURE.
2.1 Unpacking
Unpack the equipment in a clean, dry area, preferably at the installation site.
Check all items against the packing list to ensure that nothing is discarded with
the packing materials.
To prevent damage during shipment the flowmeter is packed separately. Handle
this glass tube very carefully.
NOTE: Do not discard or remove this instruction book when the installation
is completed.
2.2 Location Requirements
• Unauthorized persons must be excluded from the installation.
• Adequate access should be available to permit ease of operation, routine
maintenance and service. The gas control unit should be mounted with
the rotameter at a height suitable for reading.
• Position of the equipment in the gas storage and operation room must
correspond to local regulations.
Select a site that will meet the following requirements:
• An adequate supply of clean water is required to operate the injector.
Install the solution discharge line to the point of application as directly as
possible. A short run with a minimum of fittings is desirable (most direct
route).
• Locate gas supply containers so as to require a minimum of handling. Sup-
port in such a manner as to prevent their being knocked over.
• Both in operation and in storage give the container the protection measures
described in the Gas Handling Manual (at the rear of this book).
!