Evolveo RoboTrex H5, Руководство пользователя, Страница: 22 / 29

PUTING INTO OPERATION FOR THE FIRST TIME - AUTOMATIC CLEANING
1. This is the most common way of cleaning.
2. Insert the batteries into the remote control, make sure the polarity is correct.
3. Connect the charging station to an electrical outlet with a 230 V power adapter.
There must be no obstacles within 2 meters in front and
1 meter on the sides from the charging station.
The charging station must be placed on a flat surface,
we also recommend to fix the station to the wall or floor
with a double-sided adhesive tape.
Place the power cord so it does not get entangle in the
cleaning brushes of the vacuum cleaner.
You can also plug the 230 V power
adapter directly into the vacuum
cleaner.
4. Check that the "Main Switch" on the robotic vacuum cleaner body is in the "On"
position.
5. Place the vacuum cleaner in the charging station.
6. The vacuum cleaner battery will start charging automatically.
7. When the battery is fully charged, LEDs on the top panel go off.
8. Before putting the vacuum cleaner into operation, prepare the room so there are no
objects on the floor that may prevent the vacuum cleaner to operate properly (bigger
sheets of paper, cables, stickers, small items, inappropriately placed carpet, etc.).
9. Remove the chairs and other larger items so the vacuum cleaner can easily reach
inaccessible places.
10. To put into operation, press the "CLEAN" button on the remote control or on the top of
the device.
11. The vacuum cleaner starts cleaning automatically until the battery is almost empty,
then the vacuum cleaner automatically searches for the charging station and starts
charging the battery.
12. To pause/stop the vacuum cleaner operation, press the "CLEAN" button again.
13. Press and hold the "CLEAN" button on the vacuum cleaner for 3 seconds to switch
the device into the "Standby" mode.
14. The vacuum cleaner also switches to the "Standby" mode automatically when it is
idle for more than 15 seconds.
FIRST CLEANING

Remove all obstacles that can prevent effective cleaning.

Also remove objects that can damage the robotic vacuum cleaner.

The carpet must be secured so the robot cannot get on it when mopping. If the
mopping pad with the water container is installed on the vacuum cleaner, it may
interrupt the cleaning process or cause unwanted soaking of the carpet.

Direct sunlight may cause a reduced sensitivity of the infrared sensors of the vacuum
cleaner, please avoid direct sunlight light.