CUTTING BOWED MATERIAL
(Fig. 36)
Before cutting any workpiece, check to see if it is bowed. If it is
bowed the workpiece must be positioned and cut as shown.
Do not position the workpiece incorrectly or cut the workpiece
without the support of the fence.
(8.9)
CLEARING JAMMED MATERIAL
• Turn mitre saw “OFF” by releasing the trigger switch.
• Allow the blade to come to a complete halt.
• Unplug the mitre saw from the mains supply.
• Carefully remove any jammed material from the machine.
• Check the condition and operation of the safety guard.
• Check for any other damage to any part of the machine
e.g. the blade.
• Have any damaged parts replaced by a competent
technician and a safety inspection carried out before
using the machine again.
(8.10)
SUPPORTING LONG WORKPIECES
The free end of a long workpiece should be supported at
the same height as the machine table. The operator should
consider using a remote work piece support in addition to the
table extension bars if thought necessary.
(8.11)
INSTALLING OR REMOVING A BLADE
WARNING:
Only carry out this operation with the machine
disconnected from the mains supply.
WARNING:
Only use genuine Evolution blades which are
designed for this machine.
Ensure that the maximum speed of the blade is higher than the
speed of the motor.
Note:
It is recommended that the operator considers wearing
protective gloves when handling the blade during installation
or when changing the blade.
• Ensure the Cutting Head is in its upper position.
• Remove the lower guard operating arm from the machine
by removing the pivot screw.
(Fig. 37)
Store this screw
safely for future use.
Fig. 36
Fig. 37
27
www.evolutionpowertools.com
EN
