(8.12)
USE OF OPTIONAL EVOLUTION ACCESSORIES
Not supplied as original equipment – see optional accessories
(Page 11).
(8.13)
DUST BAG
A Dust Bag can be fitted to the extraction port at the rear of
the machine. The Dust Bag is for use when cutting wooden
materials only.
• Slide the Dust Bag over the dust extraction port,
ensuring that the spring clip grips the port holding
the Dust Bag securely in place.
(Fig. 41)
Note:
For operational efficiency empty the Dust Bag when it
becomes 2/3 full. Dispose of the contents of the Dust Bag in an
environmentally responsible way. It may be necessary to wear
a dust mask when emptying the Dust Bag.
Note:
A workshop vacuum extraction machine can be attached
to the dust extraction port if required. Follow the manufacturers
instructions if such a machine is fitted.
WARNING:
Do not use the Dust Bag when cutting
metallic materials.
MAINTENANCE
Note:
Any maintenance must be carried out with the
machine switched off and disconnected from the mains/
battery power supply.
Check that all safety features and guards are operating
correctly on a regular basis. Only use this machine if all
guards/safety features are fully operational.
All motor bearings in this machine are lubricated for life.
No further lubrication is required.
Use a clean, slightly damp cloth to clean the plastic parts of the
machine. Do not use solvents or similar products which could
damage the plastic parts.
WARNING:
Do not attempt to clean by inserting pointed objects
through openings in the machines casings etc. The machines
air vents should be cleaned using compressed dry air.
Excessive sparking may indicate the presence of dirt in the motor
or worn out carbon brushes.
Fig. 41
29
www.evolutionpowertools.com
EN
