Evoca Group Snakky SL, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 64

3
© by NECTA VENDING SOLUTIONS SpA 0303 204-00
USING THE VENDING MACHINE FOR
PACKAGED PRODUCTS
The machine can operate only as “slave”, which means
that it has to be connected to a “master” machine that can
control its functions, since the reduced electronics does
not permit autonomous operation of this vending machine.
The various functions are programmed through the selec-
tion keypad of the “master” machine, which must be of the
numeric combination type.
All models are equipped with variable configuration trays,
adding or removing dividers, spirals and ratiomotors; there-
fore the machine can be easily suited to specific needs.
All trays are preset for the operation of up to 6 selections
(maximum setting).
The compartments are equipped with independent motors
and spirals; each selection will continue its operation
autonomously even if the other selections are discon-
nected.
POSITIONING THE VENDING MACHINE
The vending machine is not suitable for outdoor installa-
tion. It must be positioned in a dry room where the tempera-
ture remains between 2°C and 32°C, and not where water
jets are used for cleaning (e.g. in large kitchens, etc.).
The machine can be used only in a bank with another
machine that can control the “master/slave” function.
The same “master” machine can control a bank with two
machines operating as “slave”.
The ventilation system allows the back panel to be leaned
against the wall, thus saving space, as air is drawn from
under the machine and exhausted through a grille on the
right-hand side. However, the grille must be completely
free without obstructions to the airflow for at least 40 cm.
If this were not possible, the spacer supplied with the
machine must be fitted to ensure the required distance
from the wall (see Fig. 2).
Warning!
Incorrect ventilation may compromise the proper func-
tioning of the cooling unit.
The machine should be positioned with a maximum incli-
nation of 2°.
If necessary provide proper levelling by way of the adjust-
able feet included.
WARNING FOR INSTALLATION
The machine installation and the following mainte-
nance operations should be carried out by qualified
personnel only, who are trained in the correct use of
the machine according to the standards in force.
The machine is sold to be connected to a “master” ma-
chine.
The composition of the bank of machines and assembly
must be carried out only in accordance with the manufac-
turer’s instructions, where necessary using the approved
kits.
The integrity of the machine and compliance with the
standards of the relevant systems must be checked at
least once a year by qualified personnel.
PRECAUTIONS IN USING THE MACHINE
The following precautions will assist in protecting the
environment:
- use biodegradable products only to clean the machine;
- adequately dispose of all containers of the products
used for loading and cleaning the machine;
- keep the machine away from heat sources;
- regularly check the condition of the door seal to limit
any heat dispersion;
- limit as much as possible door opening time during
loading operations to avoid temperature increase
inside the cabinet and subsequent power consumption.
Fig. 2
1 - Securing holes
2 - Spacer
3 - Fastening screws
4 - Can-bus connection cable