EVN SmartHome Wandthermostat Plus, Руководство по эксплуатации

Страница: 28 / 31

54 55
Before you reset the EVN SmartHome wall thermo-
stat to the factory settings, first delete the device from
the EVN SmartHome software when operating with
the EVN SmartHome Cube.
Before you teach-in a single room solution with a
EVN SmartHome Wall The to a EVN
SmartHome Cube, you must reset all devices to the
initial state.
• Press the Menu button for more than 3 seconds.
• Select the “rES” menu item with the ( + ) and ( - ) buttons.
• Confirm the setting with the OK button.
• The display will show “ACC”, confirm restored factory
settings with the OK button.
If a room control unit is taught-in to the EVN
SmartHome LAN Gateway the configuration menu
on the device will be locked. You can still restore the
factory settings:
• Remove a battery and wait for 60 seconds.
• Press and hold down reduce ( ), OK and the - button
simultaneously and insert the battery at the same time
• When „rES“ appears on the display, the reset was per-
formed and the buttons can be released.
• You can now start to make the setting.
19. Information about radio operation
Radio transmission is performed on a non-exclusive trans-
mission path, which means that there is a possibility of in-
terference occurring. Interference can also be caused by
switching operations, electrical motors or defective electri-
cal devices. The range of transmission within buildings can
differ greatly from that available in the open air. Besides the
transmitting power and the reception characteristics of the
receiver, environmental factors such as humidity in the vici-
nity have an important role to play, as do on-site structural/
screening conditions. eQ-3 Entwicklung GmbH hereby decla-
res that this device complies with the essential requirements
and other relevant regulations of Directive 1999/5/EC. You
can find the full declaration of conformity at www.eQ-3.de.