Evident Olympus SZX2-ILLTQ, Инструкция по эксплуатации

Страница: 7 / 36

3
SZX2-ILLTQ/ILLTS
Prevention of infection
Safety precautions
If the product is used in a manner not specified by this manual, the safety of the user may be imperiled. In addition, the
product may also be damaged. Always use the product according to this instruction manual.
· Wear the protective equipment such as gloves, etc.
When you observe specimens which have potentiality of infection, wear protective equipment such as gloves,
etc. to prevent the specimens from touching your skin directly.
When you maintain product which may have contacted specimens which have potentiality of infection, wear
protective equipment such as gloves, etc., or clean the product before operation.
· After observation, clean the portions where specimens contacted directly.
· Remove the specimen when moving the product.
When moving this product, be sure to remove the specimen first, since it is in danger of
dropping and spattering.
Hold the front hook of the base A with one hand and the back hook of the
base B with the other hand to prevent the base from tilting.
Remove all attached items from SZX2-ILLTQ (Quad position LED
transmitted light illumination base) or SZX2-ILLTS (Single position LED
transmitted light illumination base) and reduce the weight before holding
the illumination base.
· Take appropriate actions to prevent the product from overturning.
Take proper measures to avoid the product from falling over. In case that the product falls over, the specimen
may be dropped and spattered.
· In case the specimen is damaged, promptly take the infection prevention measures.
· When disposing of the product, follow the regulations and rules of your local government.
When disposing of the product which contacted specimens which have potentiality of infection, follow the
regulations and rules of your local government.
WARNING
Installation
· Install the product on a sturdy, level table or bench.
Use the table where the angle of installation surface is 5° or less with respect to the horizontal surface.
· Align the direction to attach the microscope frame with the direction
of the illumination light. Even if you do not use the transmitted light
illumination, be sure to set the right/left deflection angle to 15° or
less in order to prevent the product from overturning.
CAUTION
15° or less
15° or less