get into it!
6. Turn the power on and wait five seconds.
7. After a few seconds the spa should have
water flowing from the jets. If the pump has not
primed and the water is not flowing from the
jets after two minutes
TURN OFF POWER
TO THE SPA
and vent air from the pumps by
slightly opening the pump unions. (SEE
EQUIPMENT DIAGRAM).
8. The factory default setting for water tempera-
ture is 102°F (39°C). Use the TEMP pad on the
control panel to set the water temperature to
the desired level. (See TEMPERATURE
DISPLAY AND ADJUSTMENT.) Your spa will
heat at the rate of approximately one degree
per hour for 120V systems and five degrees
per hour for 240V systems.
SPA COVER
When the spa is not in use, the spa cover should
be kept on the spa to retain the water’s heat and
to keep out dirt, leaves, etc. Your heater maintains
a constant water temperature between uses.
For your safety and convenience, the cover is
equipped with adjustable straps, safety locks, and
handles. Use the exterior handles to remove and
replace your cover. We suggest that you use the
safety locks to help keep out unintended users
and prevent the cover from being blown off in
windy conditions. For high wind areas, Secure
Straps (part #8140) are available. DuraLift (part
#8225) cover lifts are also available to assist you in
cover removal. See your Everyday Hot Tubs
dealer for details.
starting your spa
Use TEMP pad to set
water temperature.
Spa cover helps
maintain a constant
water temperature.
15
