cuiheat.com
126345-01D
14
Figure 21 - Installing Rear and Middle Logs
Rear Log
Burner
Pin for
Hole in
Bottom
of Log
Middle Log
Figure 22 - Installing Front Log
Front Log
Grate
Figure 23 - Installing Top Left, Log
Top Left Log
Flat
Recess
Flat Recess
Center Top
Log
Flat
Recess
Figure 24 - Installing Center Top Log for 18'' Log Set
INSTALLATION
Continued
3. Place front log onto grate as shown in Figure 22. Front log has
cut outs for the fingers of the grate to fit into.
4. Place left top log as shown in Figure 23. This log will fit on the
matching flat recess on the middle and rear logs.
5.
For 18'' log set.
Place center top log as shown in Figure 24.
For 24'' and 30'' log set.
Place center top log as shown in Figure
25, Page 15. This log will fit on the matching flat recess on the
middle and rear logs.
6.
For 24'' and 30'' models:
Place the right top log as shown in
Figure 26, Page 15. This log will fit on the matching flat recess
on the front, middle, and rear logs.
WARNING: Failure to position the parts in ac-
cordance with these diagrams or failure to use only
parts specifically approved with this heater may result
in property damage or personal injury.
CAUTION: After installation and periodically
thereafter, check to ensure that no flame comes in
contact with any log. With the heater set to HI, check
to see if flames contact any log. If so, reposition logs
according to the log installation instructions in this
manual. Flames contacting logs will create soot.
It is very important to install these logs exactly as instructed. Do not
modify logs. Only use logs supplied with heater.
1. Place rear log onto base. Holes in bottom of log must seat over
pins on base as shown in Figure 21.
2. Place middle log onto base. Holes in bottom of log must seat over
pins on base as shown in Figure 21.
INSTALLING LOGS
LOG MODELS EWPO18R, EWPO24R AND EWPO30R
