cuiheat.com
126345-01D
13
INSTALLATION
Continued
INSTALLING OPTIONAL REMOTE ACCESSORIES
Installing Remote Receiver
Remote control accessories are available separately (see Accessories,
Page 31).
1.
If unit is already installed in fireplace, continue with these instruc-
tions. If unit has not been installed in fireplace, go to step 6 and
continue installation of remote accessory.
WARNING: Turn off heater and let cool before
handling any part of heater. Make sure gas is turned
of to unit.
WARNING: A qualified service person must connect
and disconnect gas to heater. Follow all local codes.
2.
Carefully remove logs and set aside.
3.
Locate mounting screws on sides of heater base assembly and
remove screws. Set screws aside for reinstallation.
4.
Disconnect gas line from heater base as shown in Figure 10,
Page 10.
5. Remove heater base from fireplace.
6. Disconnect jumper wire from control valve at TPTH and TH locations
(see Figure 18).
7. Connect wires to control valve at the TPTH and TH locations
as shown in Figure 19. NOTE: Make sure excess wire does not
interfere with burner or pilot.
8. If heater was removed from fireplace before installation of re-
mote accessory, see Installing Heater Base Assembly, Page 10
to reinstall heater into fireplace. Test gas connection for leaks
(see Checking Gas Connections, Page 12).
Figure 18 - Disconnecting Jumper Wire From Control Valve
Jumper
Wire
Control Valve
Figure 19 - Connecting Wires
Control Valve
Wire From
Receiver
Wire From
Receiver
9. If logs were removed from heater for install remote accessory,
replace logs (see Installing Logs, Page 14).
10. Install batteries in the remote receiver.
11. Place the remote receiver on the hearth floor next to the burner
assembly. Be certain the wires are away from the burner so they
won't become too hot.
12. Refer to installation instructions provided with remote kit for
programming and remote control operation.
