1275T / 1285T Series
Digital Clock Display
VISTALINK
®
PRO
Revision 1.0
Page - 23
5.
VISTALINK
®
PRO INTERFACE
It is possible to completely configure and operate the 1275T/1285T on the network using our
VistaLINK
®
PRO interface. The device needs to be connected to a network through a LAN / Ethernet
cable, and, manually, network information needs to be configured initially.
5.1.
OVERVIEW
This section explains the method of configuring and monitoring the 1275T/1285T using VistaLINK
PRO
®
Interface. The configuration and monitoring of the device are grouped into three physical tabs as
shown below. There are three subsections to the interface. The associated configurable items for
section are further explained in figure:
Figure
5-1: 1275T/1285T Configuration Tabs
The following table highlights the tab name and a summary of the configuration options it contains:
Tab
Description
General
The ‘General’ tab groups most of the settings of the device, including the
following:
Input:
The ability to set the source of input of Date Time.
Display:
To clearly specify whether to display Date or Time.
Daylight Saving Time:
To specify all Daylight Saving Time start and end settings.
Control Port:
The ability to specify the network port settings
IP Settings
The ‘IP Settings’ tab groups the following settings:
Trap addresses:
All IP Addresses for the SNMP TRAP settings can be configured here.
NTP Addresses:
All IP Addresses from which Network Time Protocol can be connected with
can be configured here.
Fault Traps
View the information on Fault Traps – whether there is a loss of reference.
