4
Software reporting commands
Auto report
When battery is inserted, it will report to gateway
after 2 minutes. It will report the condition every
hour.
Status change
1.
Tamper switch is on: It will report to gateway
and LED won
’
t flash
2.
Tamper switch is release: It will report to
gateway and LED will flash
Trouble Shooting
Symptoms
Possible Cause
Recommendation
Device does not work,
LED does not illuminate.
No batteries attached or
no power.
Check if batteries are
attached or replace with
new ones.
LED does illuminate,
appliance does not
respond
Binding with gateway did
not complete
successfully.
Bind again using manual
binding
Disturbed by other radio
waves
Please operate later
Reset to Factory Settings
To reset TSM04 back to factory default state:
1. Press and hold the Learning button for 3 seconds until the LED flashes
moderately then release the button.
2. Within 30 seconds, press and hold the Learning button again, this time for more
than 6 seconds then release the button.
3. Re-insert the batteries, if the LED blinks slowly for 30 seconds this implies the
device is reset back to factory mode.
Specifications
Operating temperature range
0°C to 40°C
Operating humidity
85% RH at 30°C
Battery type
AA alkaline 1.5V *1
RF Frequency
868.30 MHz/923.00MHz
RF transmission range
Outdoors >200m (Open space)
*
Specifications are subject to change without notice.
WARNING:
Do not dispose of electrical appliances as unsorted municipal waste, use separate
collection facilities. Contact your local government for information regarding the
collection systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances
can leak into the groundwater and get into the food chain, damaging your health
and well-being.
When replacing old appliances with new ones, the retailer is legally obligated to take
back your old appliance for disposal free of charge.
CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
