2
5. The following screen will appear. This means the gateway is entering binding
mode.
6. Devices with battery included : Pull out the mylar, and the LED should turn on.
Devices without battery included : Open the backplate and use a
screwdriver to
open the battery cover as below to insert the battery
7. The screen below will appear in 10 seconds if the process is successful.
Note:
Time-out will occur if the binding process was unsuccessful. Please refer
to the
“Manual Binding”.
Manual Binding
1. Remove the backplate of the detector and leaving the battery inside the
detector
2. Repeat steps 4 to 5 of the Binding with Homesys section
3. Press the Learning button for about 3 seconds and release. The LED will flash
repeatedly. This implies detector has now entered the binding mode and is
waiting to receive binding signals from the gateway.
4. Within 5 seconds, the LED indicator will flash rapidly and turn off, indicating the
learning procedure is completed. The screen below will appear indicating the
process is successful..
Learning
button
