2
7. Insert the batteries with correct polarity at this point.
8. The screen below will appear in 10 seconds if the process is successful.
9. Time-out will occur if the binding process was unsuccessful. Please refer to the
Manual Binding procedure in the Troubleshooting section.
Operation & Testing
1.
To test the wall switch, go to “Systems” and click on the Wall switch.
2.
Next, click on “Test this device”.
3.
When the above message appears, press the knob on the AC133.
4.
You should see the success message if the Gateway receives the signal. If not,
move closer to the Gateway until the test is successful.
5.
For the Wall switch to control other devices on the Homesys system, a Scenes
needs to be created. Scenes are user defined elements in Homesys that
determines what actions to take when an event occurs. The Wall switch creates
the event to this Scene which then controls other activation devices such as plugs
or dimmers, or perhaps set the alarm to Arm or Disarm mode. Refer to the
Homesys web user guide on how to create a Scene.
6.
After binding with the Gateway, the Wall Switch will send data about its battery
power to the Gateway after about 2 minutes. Subsequently it will send the data
once every 60 minutes.
Содержание AC133
Страница 1: ...AC133 e anual Manuale utente...
