23
Component Identification and Explanation
Control Panel Layout
#
Component I.D.
Component Note
1
Process Selector
Use the left and right arrow keys ( ) to select the desired welding or cutting process.
2
Display
This color LCD display provides all the information relative to setting the machine and indicating set parameters.
3
Left Adjustment
Knob
The left adjustment knob is used change the desired status of a function (i.e. voltage, turn on/off, electrode type, thickness
etc.) and to set all adjustable values to the left side of the black dividing hash mark just above the
“
EVERLAST
”
logo. If you
push in on the knob while adjusting, it will adjust in larger increments, usually in whole numbers or increments of 10.
4
Left/Right
Dividing Hash-
mark
This mark divides the functions between left side controlled functions and right side controlled functions of the machine. The
left side adjustment knob and navigation buttons control the left side of the machine. The right side adjustment knob and
navigation buttons control the right side of the machine.
5
Wire Jog
This
“
cold feeds
”
the wire through the machine to assist in threading the wire through the drive rolls and into gun without
danger of striking an arc.
6
Left Side
Navigation
Use the up and down arrow keys ( ) to navigate and select the parameter on the left side of the hash mark that you wish
to change or adjust. The actual direction may go either up and down or left and right, depending upon the function level you
are adjusting or selecting.
7
Right Side
Navigation
Use the up and down arrow keys ( ) to navigate and select the parameter on the left side of the hash mark that you wish
to change or adjust. The actual direction may go either up and down or left and right, depending upon the function level you
are adjusting or selecting.
8
PowerSet
The PowerSet function, when selected, enters a synergic mode which gives automated settings based off of the diameter of
electrode, type of metal, type of gas, and thickness you input into the unit. This simplifies operation and reduces the
knowledge base needed to make the correct adjustments needed to weld properly. When PowerSet mode is selected, some
functions of the machine will be set to automatic and will not be adjustable.
9
Right Adjustment
Knob
The right adjustment knob is used change the desired status of a function (i.e. Wire Speed, Amperage, Spool
-
gun operation
etc.) and to set all adjustable values to the left side of the black dividing hash mark just above the
“
EVERLAST
”
logo. If you
push in on the knob while adjusting, it will adjust in larger increments, usually in whole numbers or increments of 10.
6
1
2
3
4
5
7
8
9
NOTICE:
The unit is designed with several features and functions in common between processes. The principles of setup and operation carry over from one
process to another. In this case, information may not be repeated in detail in this manual if it has been discussed previously in another process..