Everglades 355 CC, Руководство пользователя

Страница: 98 / 148

98
Exterior Equipment
To use the seat, release the latch then pull the
top of the seat toward the cockpit. The bottom
of the seat slides in a track and two side supports
move out with the seat as it folds out. The seat
automatically locks into the seating position when
the cushion reaches the full down position.
To store the seat, pull the seat out slightly as you
raise the front of the seat. The rear supports will
release and slide down in the track as the seat
and side supports fold into the recess. Fold the
seat in until it is flush with the recess and align
the latch dead bolt with the receiver. The magnet
in the latch should pull the dead bolt into the re-
ceiver. Make sure the dead bolt is fully engaged
in the receiver, then rotate the safety knob to the
locked position to prevent the latch from opening
accidentally.
Work Station Baitwell
The baitwell is equipped with a Plexiglas hatch
with a “push to close” latch. It is equipped with
a light, built in overflow and recirculation pump.
It is drained by gravity to a thru-hull fitting in the
hull. The baitwell is supplied seawater by a cen-
trifugal raw water pump located in the systems
compartment. Another pump can be activated
by a switch in the helm panel to recirculate and
aerate the water in the baitwell. The overflow
built into the side of the baitwell automatically
controls the water level. The baitwell should be
drained and rinsed clean with fresh water after
each use. Refer to the Raw Water System and
Drainage Systems chapters for more information
on the operation of the baitwell.
Seat Base and Helm Seats
The helm and passenger seats are equipped with a
flip up bolster to provide more room between the
seats and the helm. The bolsters convert the seats
to a leaning post style seat with a backrest, allow-
ing the operator and passenger to sit or stand at
the helm. To convert each seat to a leaning post,
lift the front of the seat cushion to raise the bolster
and push it back above the seat cushion.
Arm rests on each side provide a more comfortable
driving position and swing up into the backrest
cushion to make it easier to enter and exit the
helm area. A molded in footrest on the rear of the
console makes the helm more comfortable when
the bolsters are set to the seat position.
Jump Seat in Seat/Step Position
Work Station Baitwell and Sink
Helm Seats in Seat Position