EverExceed Smart IT Cabin
Solution User Manual
Move the equipment to the nearest place to the final installing site, and then
unpack it.
The unpacking procedures are as follows:
1. Remove the packing materials
1) Move the equipment of assembled package to an open, firm and level
ground.
2) Use a utility knife to cut off the packing strip on the package paper box
carefully and remove the package paper box of the cabinet.
3) Use a utility knife to remove the extension film on the cabinet and the
bagging package materials
2. Remove the feed pressure plate
Use a sleeve or a moveable wrench to remove the fixing screws on the pallet,
and remove the pressure plate, as shown in Figure 2-3
Figure 2-3 Removing the feet pressure plate
3. Remove the pallet and installing cabinet components
1) Place a slope in the front or rear door of the cabinet and connect with
the pallet
2) Push the cabinet slowly from the pallet down to the ground along the
slope
3) Place the cabinet on the preserved position, and adjust the feet fixing
nut till the cabinet is level.
Note
1. When the removing the pallet, you need to prepare the slop or similar device by
yourself.
6
/
32
www.everexceed.com
