57
Multimedia LCD Projector
E
n
g
li
s
h
Lamp Replacement
When the life of the projector lamp of this projector draws to an end, the
projector would give a signal to remind you to replace the lamp with a
new one promptly.In order to maintain the lamp work efficiently
Caution: Need to cool- down the projector at lease 15 minutes
before you open the lamp cover. And make sure the projecoter is
swiched off.
Follow these steps to replace the lamp.
1. Turn over the projector. Loosen the screw and
remove the lamp cover.
2. Loosen 2 screw of the lamp and pull out the
lamp.
3. Replace the lamp with a new one and tighten the 2 screws back into position.
Make sure that the lamp is set properly. Replace the lamp cover and tighten the
screw.
Caution: Do not drop a lamp or touch a glass bulb! The glass can shatter and
may cause injury.
Note: 1. If the customer open the lamp cover when the projector is on, the lamp will
switch off automatically.
2. If the customer replace the new lamp incorrectly, the lamp would not
work properly.
Lamp cover
