38
Multimedia LCD Projector
E
n
g
lis
h
Turning off the projector
1. Press the button on the projector or remote control. The power
off confirmation message appears. If you do not want to power off the
projector, ignore the message and it will disappear.
2. Press the power button again and the projector will enter cool-down
mode. The lamp shuts off, the lamp indicator flashes red, and the fans
continue to run for approximately two minutes. During the cool down
sequence the projector will not respond to any control panel or remote
control buttons.
Caution: Do not set the power switch to off or unplug the projector during the
cool down sequence. Not allowing the lamp to cool properly will greatly reduce
the life of the lamp.
3.After the cool-down sequence is complete the fans will shut off and
the lamp indicator will stop flashing. The projector is now in standby
mode and can be turned back on with the remote control or control
panel. If the projector will not be used for an extended period, set the
power switch to off and disconnect the power cord.
**The projector will auto turn off when stay in“ no signal” status over
15 minutes.
