Page | 11
AP1004WRe Installation Guide
Regulatory Declarations
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna
or transmitter.
Important Note:
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
Important Note:
Country Code selection feature to be disabled for products marketed to the US/Canada.
Important Note:
For 2.4 GHz 802.11bgn products available in the US/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
Important Note:
The 802.11bgn/Scanning WiFi Radio Module/FCCID:2AGMRTRM989DB and 802.11ac WiFi Radio
Module/ FCCID:2AGMRTRM9995G are intended for OEM integrator only and are certified to be
compliant when installed into, but not limited to, an end product with model name, AP1004WRi and
model number, AP24I612.
