The Harmonizer
®
Programmer’s Manual
©
1999-2008 Eventide, Inc.
Page 39 of 97
Release 1.3
Refer to the separate User’s Manual on entering text for a list of the characters included in the text insert
menus. The formats shown here can be created using the
%
character, numbers, a small
f
, and a period(
.
).
As an wee exercise,
Get
the
Patch Instruct
program from the Harmonizer
(it’s found in the “Programming” bank”)
, and double click on the
knob
module. Then change the
menu statement
to “
Each Delay:%2.3fms
” as shown above.
Now
Send
the program back to the Harmonizer, and see the
difference that made to the display. Note the decimal value in
the “
Each Delay
” parameter. It used to read
250
. Now it reads
250.000
.
Contain yourself. . .
Min and Max Values
The lower and upper limits of a numeric
parameter value are set as
specifier
s in the
module that controls the parameter. In the example program
Patch Instruct
, the “
delay knob
” parameter
value has a range of
0.0000
to
10000.0000
set by the
min value
and
max value
specifier
s. You can adjust these
limits if you wish.
As another wee exercise,
Get
the
Patch Instruct
program from the Harmonizer
(it’s found in the
“Programming” bank”)
, and double click on the
knob
module. Change the
min value
and
max value
to set different
limits as shown above.
Now
Send
the program back to the Harmonizer and test the
Each
Delay
parameter. To the right we bump up against the new
min
value
.
And on this screen we bump up against the new
max value
.
You will find
min value
and
max value
specifier
s in most of the
“interface” group modules.
Resolution
The
resolution
specifier
controls what minimum change in a parameter value can be achieved by turning
the
KNOB
or by using the
INC
or
DEC
key on the numeric keypad. The
resolution
specifier
also controls the
“rate of change” as the
KNOB
is spun. If the
resolution
is very
fine
, the parameter value will increment in
“baby steps” as the
KNOB
is spun. If the
resolution
is very
course
, the parameter value will increment in
“great leaps” as the
KNOB
is spun.
For example, if the selected parameter displays a value of
45.30
and the
resolution
is
1.0000
, then slow
motion clockwise rotation on the
KNOB
will change the value to
46.30
(unless the max value is less than
46.30!)
. If the selected parameter displays a value of
45.30
and the
resolution
is
0.1000
, then slow motion
clockwise rotation on the
KNOB
will change the value to
45.40
.
As yet another wee exercise, double click on the
knob
module the same way as in the
Min
and
Max
Value
section and adjust the
resolution
specifier
. Notice the difference this makes in the “step size” of the
Each
Delay
parameter value.
(You’ll have to walk yourself through this one. . .)
Содержание H7600
Страница 2: ...This page intentionally left blank ...