RED
BLACK
BATTERY
BLA
CK
BLA
CK
CHARGER
BOARD
Indicator LED
TEST
SWITCH
)
BLUE(-)
)
BLUE(-)
)
BLUE(-)
LED
LAMP
LED
LAMP
To Remote Lamp Head
-
+
RED
RED
277 VOLT
120 VOLT
COMM
BLACK
BLACK
WHITE
RED
277 VOLT
120 VOLT
COMM
BLACK
WHITE
Transformer
Transformer
EXIT Light Bar
OPERATION:
EXIT – LED lamps will stay on in AC mode and remain on
switch.
LAMP HEADS – To test the equipment, depress the TEST
the emergency lights will illuminate. CAUTION: This equip
transfer switch which will automatically disconnect the eme
discharged to the end of its useful output.
After test, the automatic charger will return into action, cha
charged state. NOTE: Allow the battery to charge for a min
failure before conducting a 90 minute test.
TESTING
TESTING
NFPA 101 (Life Safety Code) requires that all emergency
for a minimum of 30 seconds and tested annually for a full
be kept for examination by the authority having jurisdiction
TROUBLE SHOOTING:
Does not operate in emergency mode and:
If the charger indicator light is OFF – Check that the circuit
If the charger indicator light is ON – Check that the battery
Emergency lights are dim – Implies battery might not be fu
then re-test.
MAINTENANCE:
CAUTION: Always turn OFF AC power to the equipment b
a qualified service technician. Only manufacturer SUPPLIE
BATTERY: The battery supplied with the equipment requir
periodically (see TESTING section) and replaced when it n
complete duration of a 30 second or 90 minute test. It has
ambient temperature of 72°F.
LED LAMP BOARD: When relamping, only use LED light
result in transformer damage or unsafe conditions.
OTHER: Clean lenses and replace lamp as, and when, req
Wiring Diagram
NOTE: Unused input leads must be properly
insulated with wire nuts or other approved
methods
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
IMPORTANT SAFEGUARDS: When using electrical equipment, always
methods.
in the Emergency mode. To peform test, press test
T switch. The charge (LED) indicator will turn OFF and
pment is furnished with a sophisticated solid state
ergency lights from the battery if the battery has been
arging the battery and trying to maintain it at a fully
nimum of 24 hours after installation or after a power
lighting equipment be functionally tested every 30 days
90 minute duration. Written records of the testing are to
n.
t breaker for AC supply is ON.
is properly connected.
ully charged. Allow battery to recharge for 24 hours and
before servicing. Servicing should be performed only by
ED or APPROVED replacement parts must be used.
res ZERO maintenance. However it should be tested
no longer operates the connected fixtures for the
a life expectancy of 5-7 years when used in a normal
sources specified. Using other LED light source may
quired.
s adhere to basic safety precautions including the following: