Evenflo LiteMax DLX, Руководство пользователя

Страница: 28 / 61

54 55
Installing the Convenience Base with the
Lower Anchor Connector Assembly (cont.)
Using your full weight,
push the base into the
vehicle seat while pulling
up on the strap to
remove all slack from the
lower anchor connector
assembly.
Place any excess lower
anchor connector webbing
to the side of the base. Do
Not route it back under the
Lock-off. Close the Lock-Off
until it clicks into place.
Note: If unable to close the
Lock-Off, loosen the lower
anchor connector assembly
and try again.
Close One Step Lock-Off
7
6
Installing the Convenience Base with the
Lower Anchor Connector Assembly (cont.)
Make sure the lower
anchor connector assembly
harness is tight. Grab
the base at the areas as
shown. If you can move
the base more than 2.5 cm
(1 in.) side-to-side or front
to back, the harness is
not tight enough. You will
need to try again or find
another location for your
convenience base.
WARNING!
DEATH or SERIOUS
INJURY can occur.
Place carrier on base, re-check level,
see p. 64-65.
To remove lower anchor connector, see p. 94.
8