Evenflo ExerSaucer, Инструкция по эксплуатации

Страница: 5 / 21

6 7
Attaching the Toys
+
+
+ –
–
–
Batteries
Remove screw from battery door.
Replace screw J> ^ after batteries have
been replaced. DO NOT OVERTIGHTEN .
Assembling the Art Table
STAGE 2 STAGE 2
1. Remove Base
H
from bottom of
ExerSaucer.
Note:
Remove all toys from ExerSaucer
before assembling the Art Table.
2. Turn ExerSaucer upside down.
3. Remove Bounce Ring D> ! from Tray.
Push tab D> @ until it releases from Tray.
Repeat until all six tabs are released
from Tray.
To secure Spin-Loc toys on ExerSaucer
Tray, set toys on Tray and twist toy base J> # ,
clockwise as shown. Pull up on toys to make
sure they are locked in place.
To remove Spin-Loc toys from Tray, twist toy
base counterclockwise, squeeze tabs J> $ and
lift, as shown.
If Spin-Loc toy does not stay attached, clean
suction cup per cleaning instructions for
plastic parts on page 9.
Secure Spin-Loc™ toys every time the
ExerSaucer is used.
To place toy with cap on ExerSaucer, set
toy cap J> ! on top of Leg, as shown. Push
down until tab J> @ rests in dimple A> ! on
Leg to ensure toy is attached properly.
To remove toy from ExerSaucer, grab cap
and pull straight up.
To remove batteries from mirror toy,
remove two screws J> % , and lift mirror face.
To replace mirror face, replace screws.
DO NOT OVERTIGHTEN .
J> !
J> @
A> !
J> #
J> $
H
H
D> @
D> !
WARNING
Stage 2 is for use by children who can walk unassisted
up to approximately 48 months.
Stage 2 Art Table MUST be in highest position at all times.
WARNING
Toys with cap MUST be in place
when Stage 1 is in use.
WARNING
J> %
Refer to battery door
for quantity and size
of batteries.
J> ^