4
5
7.
Turn Seat Ring
E
right side up. Align triangles
E> @
on the back of the Seat Ring
with the triangles
G> !
on the seat pad label. Snap the plastic tabs
G> @
on the
pad over the pegs
E> #
on the Seat Ring. Continue this process until all tabs are
attached to all pegs.
6.
Place Seat Ring
E
upside down and locate the wheel holders
E> !
.
Click six (6) Seat Wheels
F
into wheel holders, as shown.
E> !
E
F
E
G
G> !
E> @
E> #
G> @
Assembling the ExerSaucer
8.
Press assembled
Seat Ring
E> $
down firmly onto
the Bounce Ring
D> !
until it clicks
into place and
spins freely.
To adjust height:
ALWAYS
remove baby from ExerSaucer before
adjusting.
Squeeze tabs
C> !
while unscrewing Hand Lock
C
.
Unscrew only far enough to free the Hand Lock
from the opening in the Tray. Move the Tray
up or down to the desired height, then tighten
the Hand Lock until it locks in place.
DO NOT
OVERTIGHTEN
.
IMPORTANT:
When inserting Hand Locks, use
the same opening in each Leg Assembly, or the
ExerSaucer will not be level.
During use, allow the baby’s toes only to touch the Base.
DO NOT
allow
the baby to stand flat-footed on the Base. As baby grows and becomes
more active, raise the Tray to the next level so that baby enjoys the most
comfortable fit and maximum use of the spin, and bounce features.
E> $
D> !
Assembling the ExerSaucer
4.
After all four Legs are locked in place,
turn the ExerSaucer right-side-up.
CLICK!
CLICK!
WARNING
Loosen
Tighten
H
I
C> !
H
A
CLICK!
5.
Place Base
H
on Legs
A
under the
ExerSaucer. Make sure the Base is
resting in the notches on the Legs, as
shown. Then place the Base Cap
I
in
the center of the Base.
IMPORTANT:
Base
H
MUST
be in
place before using Stage 1.
Base Cap
I
MUST
be placed in the
Base with the rim facing down, as
shown.
