Main board./Automatic machine configuration
VENDING MACHINE
27
This menu can be used for the modem parameters settings, when a telemetric function is
used.
➢
GPRS
•
Configuration
✓
Automatic. The telemetric module modem uses the telecommunication
network automatic parameters settings.
✓
Manual. With this function selected the network parameters should be
defined (APN, User name, Password)
•
APN. APN network name should be entered.(Access point Name).
•
Network user name. The use name should be entered.
•
Password. The password should be entered.
•
The information regarding (APN, User name, Password) will be received
together with SIM card, for the particular telecommunication network operator.
2.3.7. Test
This menu enables the tests performance for the particular devices connected to the main
board. The menu can be expanded into the following submenus (key „#”):
➢
Motor test,
➢
Motor auto-test,
➢
Keyboard test,
➢
Display test,
➢
Photocell test,
➢
Power supply test.
Motor test.
Enables the test performance for the particular motors. The motor selection is made via the
keyboard. The principle of the test is turning the motor until a signal reception from a limit
switch. After receiving the signal the motor
will be stopped and „OK” message will be
displayed. When the signal is not received the motor will be stopped after previously defined
period. In case of motor lack or shortcut the test is ceased immediately. That case is signaled
with „NOK” message.
Motor auto-test.
Enables the automatic test performance for all of the motors. After the test termination the
message will be displayed. If any motors are inoperative the message on faults will be
displayed. The test should be performed during the first machine startup in order to restart
the motors and after each reset to the Factory settings.
Keyboard test.
It consists of displaying a pressed key on LCD display.
Display test.
Pressing # key cause displaying a letter sequence.
ABCDEFGHIJKLMNOPQRST
UVWXYZ0123456789abcd
Photocell test.
The test consist of a calibration performance. If the test is passed then OK message will be
displayed, if the test is failed then Error message will be displayed. When the error message
is displayed the verification of 100
% “visibility” for the photocells should be performed,
followed by retest.
Power supply test.
The main board voltage value will be displayed.
Содержание SOLID AS 6x10
