Evco RICS 4.30, Руководство пользователя

Страница: 25 / 104

13 RICS
Main display
1.5 The device inspector
The Device inspector allows you to visualise the status of the outputs, the value measured by the main probe, the
setpoint and the machine status of the chosen device, without leaving the main display. You can allow the display
of the Device inspector on Main menu>Configure>General>Lay-Out/Graphics>Device Inspector. After
this select the option Sticked to main panel.
Just click on a device or, if the function has been set, hover over the chosen device icon with the mouse for a few seconds
to see data from the Device inspector.
1.5.1 Display of the value measured by the main probe
The values measured by the first probe are seen in a large font for easy reading, even if the device image (and related
display) are very small.
1.5.2 Display of general status
defrosting: defrosting now
temperature reduction: reducing temperature.
1.5.3 Display of input and output status
If the device displayed has relay outputs or input contacts, you can see their current status on a series of virtual LEDs.
Note that in many cases the input contacts can be seen as active, or not, depending on the type of device, the type of
external contact and the eventual programming of the parameters.
You can see the name associated to an input/output by moving the mouse pointer over the relative virtual LED.
1.5.4 Display of the device’s main setpoint
For many sorts of device (where there is the concept of main setpoint) you can see the value of the main setpoint on the
Device inspector.
1.5.5 Rapid modification of the device’s main setpoint
You can rapidly modify the value of the main setpoint on the Device inspector. Just click on the displayed setpoint value
to activate the field that allows it to be modified.
This function can only be accessed if you have sufficient system privileges (see Chapter 2).
1.6 Virtual rooms
On the main display you can display all connected devices. However in some cases it can be helpful to sub-divide the
devices in sub-groups, displaying them one at a time.
In RICS these groups are called virtual rooms (or more simply “rooms”).
To modify the settings of these virtual rooms go to Main menu>Configure>Pages/rooms (see paragraph
7.1).