EvaKool MAXI TRAC MT-45, Инструкция по эксплуатации

Страница: 5 / 20

5
2. Operating Instructions
2a Initial Startup
Pre check:
• For hygiene reasons we recommend cleaning the inside of the cabinet before use (see
section 4 defrosting and cleaning) .
• Your unit requires good ventilation especially around the vents of the engine
compartment, allow at least 100mm gap around all vents .
(Warning: Do not operated unit in an unventilated confined space, E.g. storage box or
cupboards in caravans and camper trailers. Doing so may cause damage to the unit).
• When using the unit ensure the electrical circuit being used has a fuse or circuit breaker .
(12V DC 15 Amps . 24V DC 7 .5 Amps) .
Ready to go:
• 12 and 24 Volt DC: Plug the DC connection cable into the DC socket located on the
motor compartment end of the unit (the unit will automatically detect the DC voltage
applied 12 or 24 volts) .
• Mains power AC: Plug the AC connection cable in the AC socket located on the motor
compartment end of the unit . Then plug the 3-pin plug into the wall socket .
• Press and hold the for 3 seconds . The display will light up, showing the temperature
inside the unit . You will hear the compressor start first then the cooling fan will start .
Your fridge is running .
•
For a single zone.
Press or buttons to set the desired temperature inside the
fridge .
•
For a dual zone.
Press once, the left display will start to flash, use the or
buttons to set the desired temperature . Press again, the right display will start to
flash, use the or buttons to set the desired temperatures . Press again to lock
in settings .
• The unit will start to cool . Depending on the size and design of the unit, and your set
temperature it should take between 60 and 120 minutes to reach its set temperature .
Single Zone - @24°C ambient, set at 4°C, no product inside .
Dual Zone - @24°C ambient fridge set at 4°C, freezer set at -16°C, no product inside .
*These are average cycle times, this will vary depending on ambient temperature, heat load, etc.
N.B: Always allow 24 hrs for unit to achieve proper running conditions
• Initial start up
• After changing the set temperature on the display .
• Allowing hot product to come down to temperature .