EUTECH INSTRUMENTS CYBERSCAN PH 1100 2100 PHION METER, Инструкция по эксплуатации, Страница: 10 / 64

Instruction Manual pH 1100/ 2100
10
2 STARTING UP
Attention:
Do not get water on the BNC connector during operation.
Avoid touching the connector with soiled or wet hands.
2.1 Back Panel Connections
Refer back to
Figure 2 . Make the necessary connections as mentioned in Section 1.3 Rear Panel, pg 8 .
2.2 Powering up and powering down
2.2.1 Powering up
1. When first connected to the power supply, the meter runs a
self test, the display flashes Hardware Testing... Status:
Pass.
See
Figure 5 .
2. It then displays current date and time. See Figure 6 . This
display will also appear when the meter is turned off while
still connected to the power supply. See
Figure 6 .
3. See Figure 7 . To turn the meter on press ON/OFF. The
upper display flashes Bench pH/Ion 2100 for the pH 2100,
(Display flashes Bench pH 1100 for the pH 1100 meter.)
and then the lower display flashes SW Rev 1.20. See
Figure 7 .
4. The display flashes
System Initializing, Please wait...
See Figure 8 .
5. If this is the first power up since the power was connected,
you must indicate desired measurement mode. Use >/CAL
to select. The mode selected will flash. See Figure 9 .
Press ENTER to confirm. The meter then enters
measurement mode.
6. After initial startup, the meter will automatically return to
the measurement mode previously selected as long as
power connection is maintained.
2.2.2 Powering down
1. To turn the meter off press ON/OFF . The display flashes
System Shutting Down, Please wait... See Figure 10 .
Then, the date and time display will appear. See Figure 6 .
The date and time will continue to display until the power
supply is disconnected.
Hardware Testing. . . .
Status: Pass
Date Time
Jan 25 2002 09:09:30
System Initializing
Please wait. . .
pH/Temp mV Ion
Select & Press ENTER
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Bench pH/Ion 2100
SW Rev 1.20
System Shutting Down
Please wait. . .