– 10 –
Start inclusion mode of your primary Z-Wave Controller.
Press the network button
three times within 1 second
.
While the inclusion is active, the LED is blinking green. If the inclusion was successful the green LED will
light up for 5 seconds. Otherwise the red led will light up for 5 seconds to indicate failure.
Start Exclusion mode of your primary Z-Wave Controller.
Press the network button
three times within 1 second
.
While the inclusion is active, the LED is blinking green. If the inclusion was successful the green LED will light
up for 5 seconds. Otherwise the red led will light up for 5 seconds to indicate failure.
Press and hold
the network button for at
least 10 seconds
. The Temperature & Humidity Sensor Z-Wave Plus
will indicate the reset blinking pattern once the reset is completed.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
7.4 Add Temperature & Humidity Sensor Z-Wave Plus to a Z-Wave network
(Inclusion)
7.5 Remove Temperature & Humidity Sensor Z-Wave Plus from a Z-Wave network
(Exclusion)
7.6 Factory reset
