5
ENGLISH
FIG. 2
Z
U
INSTALLATION INSTRUCTIONS
Read these instructions carefully and completely before you install the machine. The installation should be
carried out by a qualified person who is familiar with all local codes and ordinances for electrical and
plumbing connections. Incorrect installation may cause damage and/or injury. If the integrity of the machine
is in doubt, do not use it. Call your dealer for qualified assistance.
The washer can be installed anywhere provided that the temperature is not less than 38° F (3° C) and the
electrical cords and hoses behind the machine are not cramped.
To install the washing machine, follow the steps below:
1.
Move the machine to its installation position and remove the outer
wrapping and the polystyrene base.
2.
Model EWF150 has a plastic strip taped to the bottom of the machine
to secure two cones that prevent the tub from moving during
shipment. This plastic strip and the cones must be removed. To do
this, simply peel away the tape on the bottom sides of the unit that
hold the plastic strip and cones in place.
NOTE: Failure to remove these cones will likely cause the unit to
vibrate excessively during the spin cycles.
3.
The drum
on both models is locked in position. Loosen the four
locking bolts and remove them along with the plastic spacers
(Fig. 1).
NOTE: If the plastic spacers cannot be removed, open the side
panel by loosening the screws indicated as “V” in
Fig. 1. Remove the spacers and replace the panel.
4.
Next, loosen the two locking screws (Z) and remove the two pins
(U), as illustrated in Fig. 2. Keep the bolts, screws and pins for
future use.
5.
Plug the holes with the plastic plugs provided with the unit (packed
inside the drum with the documentation) (Fig. 3).
6.
To level the machine, adjust the feet by screwing or unscrewing as
needed. Once the machine is level, tighten the locknuts (Fig. 4).
V
FIG. 1
FIG. 3
FIG. 4
