Eurotech DynaGate 10-12 Series, Руководство пользователя

Страница: 58 / 94

9 How to supply power to the product DynaGATE 10-12 User manual Rev. 0-14
9.2 How to supply power and turn ON the product
WARNING
ELECTRIC SHOCK HAZARD
Failure to supply power correctly, or failure to follow all operating instructions correctly, may
create an electric shock hazard, which could result in personal injury or loss of life, and / or
damage to equipment or other property.
To avoid injuries:
l
Do not perform any connections with wet hands
l
Check any power cords for damage before using them
l
Use certified power cables. The power cables must meet the power requirements of the
devices
l
Position cables with care. Avoid positioning cables in places where they may be
trampled or compressed by objects placed on them
l
Take particular care of plugs, power-points and outlets. Avoid overcharging them
l
Before applying power, thoroughly review all installation, operation, and safety
instructions
l
Before operating any equipment, carefully read any supplied instructions
l
Always disconnect power and discharge the circuits before touching them
l
Only start the product with a power supply that meets the requirements stated on the
voltage label. In case of uncertainties about the required power supply, contact the
Eurotech Technical Support Team (see the back cover for full contact details) or the
electricity authority.
To supply power to the DynaGATE 10-12, complete the following steps:
1. Set up a DC power source that:
o
Meets the DynaGATE 10-12 power requirements
o
Deliver a maximum current of 2 A
Check the input voltage as close as possible to the Power IN connector. This is to compensate for
any cable losses, caused by cable length and other cable characteristics
2. Make sure that the DC power source is turned OFF
3. Include an external 2 A fuse on the line coming from the negative terminal of the DC power source
to protect the DynaGATE 10-12
4. Connect the DC power source terminals to Pins 1 and 2 of the Power IN connector.
1 3
Power IN + Power IN -
5. Turn ON the DC power source. The DynaGATE 10-12 automatically turns ON and the LED 6
(POWER) turns ON.
Note about the Vehicle Ignition Sense
The Vehicle Ignition Sense is a digital input that can be used to monitor the ignition status.
The DynaGATE 10-12 turns ON independently of the status of the Vehicle Ignition Sense (for further
information see
"Vehicle Ignition Sense" on page 73 ).
58 / 94