EUROPEAN FINISHING EQUIPMENT EVG - 24 Series, Инструкция по эксплуатации и безопасности

Страница: 5 / 26

5
7. Close the water cap by pressing down and turning clockwise. Do not overtighten.
8. Plug boiler into grounded outlet of sufficient power (110/120 Volts, 15 AMPS).
9. Turn on iron switch (Fig. 2, “A”) and boiler switch (Fig. 2, “B”). Both switches will light up.
10. Set thermostat knob on the iron (Fig. 3) to desired temperature. These temperature settings are
approximate. Always check temperature on a hidden part of garment. The setting for steam is
“Cotton” (“ ∙∙∙ ”) or higher.
11. When the pressure gauge reads approximately 40 PSI and the boiler lamp (Fig. 2, “C”) is off,
you are ready to press. During ironing this light will go on and off and the pressure gauge needle
will move up and down. This is normal operating function.
Fig. 2
KNOB FOR STEAM
ADJUSTMENT
WATER FILLING
TROLLEY
CONNECTION
D
C
B
A