Cleaning the main tube burner
1. To clean the gas ports of your main burners
use a stiff bristle brush to brush the openings
MAINTENANCE
by authorized p
use a stiff bristle brush to brush the openings.
2. Refer to: Removal of burners for the removal
of the burner tube.
3. you can now lift the burner tube out of the
burner box and inspect inside with a flashlight.
4. Clean the inside of the burners with a wire
(a straightened-out coat hanger will work).
Check and clean the air shutter openings at the
ends of the b rners
ends of the burners.
5. Check and clean the valve orifices on the valves.
Use a steel bristle brush to clean the outside of the
burners. This is to make sure that all burner ports
are fully open.
Cleaning the tube burner entry
To clean the inlet of the burner, bend a stiff wire o
wire coat hanger into a small hook as shown and pus
wire coat hanger into a small hook as shown and pus
the wire into the inlet of the burner tube several times
to remove any debris. Alternatively you can use a bot
cleaner brush, or use an air hose to force air through
the tube.
Replacing the Main tube burners
1. Your gas barbecue must be OFF and cool.
T
2. Turn OFF gas source.
3. Remove the cooking grate and the flame tamers,
exposing the burner tubes.
4. Remove control knobs, bezels and disconnect
wire to the electronic igniter for the rotisserie
burner.
5. Then remove the control panel.
To reassemble, reverse steps 3 through 5 ab
,
p
g
CAUTION: The burner openings must be
positioned properly over the valve orifice.
Check proper assembly before fastening
manifold/control panel in place.
WARNING: After reinstalling the gas lines,
h
h ld b l k
i h
d
they should be leak test with a soap and
water solution before using the barbecue.
Battery
Unscr
old ba
wrap m
install
person only
e
s
or
sh
sh
s
ttle
h
bove
y replacement of rotisserie burner igniter
rew the push button igniter and remove the
attery and replace with a new one. The shrink
must be removed from the battery before
lation.