Built in Natural Gas and P
This barbecue must be installed in accord
authorities, gas, electricity and any other
latest published versions of AS/NZS 5601
li d l
ti
cylinder location.
Natural gas conversion and installation m
authorised person using the approved nat
sizes, Part No Ngkit1. The regulator must
operating, the pressure test point is locate
M t NOT b i t ll d ithi 1000
f
Must NOT be installed within 1000mm of
bricks.
Gas inlet connection is located at the fron
750mm above the floor. The inlet connecti
high Flexible connection must be certified
high. Flexible connection must be certified
10mm in diameter and up to 1500mm lon
hot surface. The installer must test the op
The tradesperson must build the minimum
The tradesperson must build the minimum
shown, when the barbecue is in the instal
provided to ensure the hose and regulator
connected/disconnected to the barbecue g
750mm clearance below the barbecue is r
ventilation must be at least 200cm² openin
ground level) and 200cm² openings at the
bl
f t
3 4&5
assembly, refer to pages 3, 4&5.
Propane LPG Installation
dance with the requirements of local
statutory regulations, as well as the
Gas Installations, pipe sizing and LPG
must only be performed by an
tural gas conversion kit and injector
be set to 1.0kPa, with all burners
ed on the regulator.
h d
f
h
t
overhead surfaces such as concrete or
t right hand side of the barbecue,
ion thread is 5/8”SAE male flare and
d to class B or D of AS/NZS1869
d to class B or D of AS/NZS1869,
ng and must not be in contact with any
peration of the barbecue and instruct
m combustion air inlet clearances as
m combustion air inlet clearances as
lled position, adequate access must be
r assembly can be easily
gas inlet. If an LPG cylinder is used,
equired and the cylinder enclosure
ngs at the bottom(below 125mm from
top of the enclosure. For barbecue
the overall dimensions are
1060m
m long, 61
5
mm wide and
605
mm or 1240mm
the user before leaving. If the barbecue caannot be adjusted to perform correctly
or for parts or service, our nationwide service team can be contacted on our toll free
customer service number 1800 805 300 or by logging on to customersupport.hapl.com.au