24
Display:
1. Stand-by light
2. Day indicator
3. Temperature and thermostat setting
4. Time indicator and timer setting
5. Lamps of 1000W - 2000W - auto
6. Dimmer setting
7. Operating timer light
8. Timer ON & OFF setting
INSTALLATION AND CONNECTION
Remove the packaging materials and keep out of the reach of children. After removing
packaging, check device for damage or any evidence that may point to a defect/failure.
If in doubt, do not use the device but refer to your supplier for checks/repairs.
Generally the fire will be placed against a wall. Place the heater on a sturdy, flat
surface. The substrate must be heat-resistant. Make sure that the suction grilles are
never blocked!
Choose a suitable location for the fireplace, at least one metre from all obstructions,
walls and flammable materials (see safety instructions) and in the vicinity of a 16 Amp
(at least) fused,
earthed
electrical socket (protected by a 30 mA earth leakage circuit
breaker).
OPERATING
Check that the details on the data plate correspond to those of the electrical supply
which you wish to use for the fireplace. Do not use the same connection for any other
equipment.
Install two AAA-1,5V batteries in the remote control.
Check whether the main switch is set to OFF (
O
is pushed in)
Now insert the plug into the
grounded
socket.
Push the main switch to ON (
I
is pushed in). The stove is now on stand-by and the
light is switched on at the
You can now further operate the fireplace with the remote control or with the buttons
on the fireplace itself.
Push-button operation
If you don't use the remote control, you can press the relevant buttons on the control
panel, manually set it to 3 positions; the corresponding lights will turn on.
-
I/O : flame effect only
-
I/O + 1000W : flame display and heating at 1000W
-
I/O + 2000W : flame display and heating at 2000 Watt (all the lights are turned on).
By pressing the I/O button longer, you initiate the dimmer function; the light intensity will
increase or decrease with every tweet. Release the button when you have achieved the
desired intensity
Attention! The thermostat cannot be set manually, only with the remote control. The
thermostat is standard set to 20°C.
