00066709.DOC, Version 1.1
22/23
If several LED PAR-64 RGB 36x5W Short are addressed similarly, they will work synchronically.
Press the Menu-buttons and the Up/Down-buttons for setting the desired starting address. Now you can start
operating the LED PAR-64 RGB 36x5W Short via your lighting controller.
Note:
The modes of DMX 512 data are shown via the DMX indicator.
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the control LED lights up permanently.
If there is no data received at the DMX-input, the control LED will be off.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective,
- the cable or connector is defective or the signal wires are not properly connected with the input connector.
Attention:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
CLEANING AND MAINTENANCE
Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
