00051238.DOC, Version 1.1
31/35
Caution:
At the last fixture, the DMX cable has to be terminated. Plug the terminator with a 120
resistor
between Signal (–) and Signal (+) in the DMX output of the last fixture.
6. OPERATION
With the POWER-switch, you can switch the device on and off.
Turn the keyswitch to ON.
Spatial effects of the projection patterns can be created by using a smoke-machine. Make sure that you do
not use too much smoke so that the laser beam is swallowed after a short distance and the audience cannot
see the projections.
When laser is powered on, LED monitor on rear panel shows the current operating standalone mode or DMX
address of DMX mode. With help of LED control panel, it is very easy to set and change the operating mode
of laser. After every resetting and saved, the new mode information will be shown on LED monitor at next
power on.
Mode/Function Option, to choose the operating mode of laser.
Confirmation, to confirm all setting or change of LED control panel.
UP/DOWN, to change operating mode, parameter or DMX address.
Stand Alone Preprogram Laser Show
Press FUNC to enter MODE OPTION.
Till to LED panel shows either one of ArA, ASr, AFd, ASd, SrA, SSr, SFd, SSd.
Press UP or DOWN to select your favorite Stand Alone mode as above.
Press ENTER to confirm the setting.
The laser is working in stand alone. Each time when you turn on your laser, you will have this confirmed
laser show.
In the MODE OPTION setting, the stand alone laser show that you are going to choose is flashing. Press UP
or DOWN to change stand alone laser show, you will have 8 different stand alone preprogrammed laser
show. Their DISPLAY and EFFECT are listed below:
DISPLAY
STAND ALONE MODE LASER EFFECT
ArA
Mixed laser effect
A
uto show with
rA
ndom order
ASr
A
uto mixed
S
low laser effect with
r
andom order
AFd
A
uto
F
ast
d
ots laser effect
ASd
A
uto
S
low
d
ots laser effect
