00091062.DOC, Version 1.1
28/28
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an expert after
every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a skilled person
once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension, trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or sediments.
Further instructions depending on the installation spot and usage have to be adhered by a skilled installer and any
safety problems have to be removed.
Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use alcohol or
solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are only to be
carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step
1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2:
Remove the old fuse from the fuseholder.
Step 3:
Install the new fuse in the fuseholder.
Step 4:
Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply cable
available at your dealer.
Should
you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
100-240 V AC, 50/60 Hz ~
Power consumption:
24 W
DMX-control-channels:
3/10
DMX-512-connection:
3-pin XLR
Sound-control:
via built-in microphone
Maximum ambient temperature Ta:
45° C
Maximum housing temperature TC:
50° C
Min.distance from flammable surfaces:
0.5 m
Min.distance to lighted object:
0.1 m
Fuse:
T 1 A, 250V
LED type:
3 W LED RGBAWP
Number of LEDs:
6
Dimensions (LxWxH):
200 x 300 x 310 mm
Weight:
3.2 kg
Accessories:
No.:
TPC-10 Coupler, silver
59006856
Safety bond AG-5 3x600mm up to 5kg
58010360
XLR cable 3pin 3m black
3022047N
XLR plug 3pin 110 Ohm
30208430
SB-10 Soft bag
30130500
IR-7 Remote control
50530561
Please note: All information is subject to change without prior notice. 27.08.2015 ©
