00116794, Version 1.0
36/56
4. Select the desired scanner.
5. Press
TAP/DISPLAY
to switch between 8-channel and 16-channel mode.
The display shows either ‘ASSXX XX | X/Y 08CH’ or ‘ASSXX XX | X/Y
16CH’.
8-channel mode: You can assign the PAN/TILT movement for 24 scanners.
In 8-channel mode, you can save PAN/TILT for page A and page B.
16-channel mode: You can assign the PAN/TILT movement for 12
scanners. In 16-channel mode, you can save PAN/TILT only for page A or
page B.
6. If necessary, you can use
PAGE SELECT
to switch between levels Page A
and Page B.
7. While you keep
MODE
pressed, press the
SCENES
button. All LEDs should
flash briefly and thus indicating that the DMX channel has been assigned.
The button SCENES 1 stands for DMX channel 1, SCENES 2 for DMX
channel 2 and so on.
8. Repeat steps 3 – 7 to assign the pan/tilt channels of further scanners.
Inverting Output Values for Pan/Tilt
1. Enable programming mode.
2. Simultaneously press
FINE
and
MODE
. The LED
REVERSE
lights up and
thus indicates that the device is in reverse mode.
3. With
BANK UP/DOWN
you can switch between Pan and Tilt. The
corresponding LED indicates your selection.
4. Select the desired scanner.
