00133036, Version 1.0
32/44
Note:
The modes of DMX512 data are shown via the display of the device:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the display will show
"d.001"
with the actually set address. If there is no data received at the
DMX-input, the display will show
"d001"
with the actually set address.
This situation can occur if:
- the wireless receiver is not logged in to the wireless transmitter or no wireless DMX signal is received.
- the controller is switched off or defective.
CHARGING
Prior to operating the device off mains for the first time, the rechargeable battery must be fully charged. You
can charge the product using the charging adapter.
1
For charging the battery, connect the device to a grounded mains socket (100 und 240 Volt) via the
enclosed power unit. Charging time is 3 hours. The device may be operated during the charging
procedure.
2
Switch on the device on using the ON/OFF switch. The operating time of the battery depends on the
operating mode and the ambient temperature (max. 13 hours). After the operation, switch the device off.
3
The device features a protective circuit for charging which prevents overload of the rechargeable battery.
However, disconnect the device from the mains after charging. Otherwise there will be a low current
consumption even if the device is switched off.
4
The device will heat up during charging; this is normal.
5
To prevent damage to the battery by deep discharge, recharge a completely discharged battery as soon
as possible. Do not store the unit with the battery completely discharged and regularly recharge the
battery in case of long storage.
Maximum battery run time
Recharge time
13 hours
3 hours
Please make sure to close the cap of the charger input after charging in order to prevent the
penetration of humidity and dirt.
Battery status
The battery charging status is indicated on the display. The battery charging status is indicated by four
levels. If all four levels are lit, the battery is fully loaded. If only one level is lit, the red one, the battery is
going flat soon. In this state, the device can be operated for a few minutes. Then an emergency switch-off
deactivates the device to protect it from total discharge.
Содержание AKKU Bar-3
Страница 1: ......
