EURO ESINF600B, Инструкция по использованию и уходу

Страница: 35 / 40

35
Once the countdown has finished, the timed
plate will turn off and a series of beeps will be
heard. They can be stopped by touching either
of the sensors
(12) or (13) associated
with the clock.
Disconnecting the clock
If you wish to stop the clock before the program-
med time is up, this can be done at any time by
simply adjusting its value to '
-- '.
1 Select the plate you wish to stop the timer on
by directly touching its corresponding indica-
tor (3).
2 Adjust the value of the clock to " -- " by using
the "less" sensor (12). This can also be done
more quickly by pushing the "less" and "more"
sensors
(12) and (13) at the same time.
Total Zone Function
By using this function it is possible to achieve
that two plates, as shown in the screen, function
at the same time, both for selecting a power
level as well as for activating the timer function.
To activate this function you should press the
sensor
or (16). Upon doing so, the deci-
mal points (9) of the plates light up and both turn
to power level 5.
The timer (5) of the lower plate will turn off, and
from then on it will be the upper one that indica-
tes the values of the clock for both.
To deactivate this function you should press the
sensor again
or (16). cal service can
handle or repair the appliance, including repla-
cement of the power cable.
Do not step on the glass or lean on it as
it could break and cause injury. Do not use
the glass as a surface for placing objects.
The Manufacturer
reserves the right to make
changes to its manuals that it deems necessary
or useful, without affecting the product's essen-
tial features.
Suggestions and
recommendations
* Use pots or pans with thick, completely flat
bottoms (see fig. 4).
* Pots/pans with a smaller diameter than the
shown heating area are not recommended.
* Do not slide pots and pans over the glass
because they could scratch it.
* Although the glass can take knocks from large
pots and pans without sharp edges, try not to
knock it.
* To avoid damaging the ceramic glass surface,
do not drag pots and pans over the glass and
keep the undersides of them clean and in
good condition.
Try not to spill sugar or products
containing sugar on the glass as while the
surface is hot these could damage it.
fig. 4
Right
Wrong Wrong