EURO ESINF600B, Инструкция по использованию и уходу

Страница: 22 / 40

60 cm.
22
Installation
Installation with cutlery drawer
If you wish to install furniture or a cutlery drawer
under the hob, a separation board must be fitted
between the two. Accidental contact with the hot
surface of the device's housing is thus preven-
ted.
The board must be fitted 20 mm beneath the
under part of the stovetop.
Electrical connection
Before you connect the stovetop to the mains,
check that the voltage and frequency match
those specified on the stovetop nameplate,
which is under-neath it, and on the Guarantee
Sheet, or if applicable on the technical data
sheet, which you must keep together with this
manual throughout the product's service life.
Ensure that the inlet cable does not come into
contact with the induction top housing or the
oven housing, if it is installed in the same unit.
Warning:
The electrical connection must be pro-
perly grounded, following current legisla-
tion, otherwise the induction hob may mal-
function.
Unusually high power surges can
damage the control system (like with any
electrical appliance).
It is advised to refrain from using the
induction hob during the pyrolytic cleaning
function in the case of pyrolytic ovens, due
to the high temperature that this type of devi-
ce attains.
Only the official technical service can
handle or repair the appliance, If the supply
cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Before disconnecting the hob form the
mains, we recommend switching off the cut-
off switch and waiting for approximately 25
seconds before disconnecting from the
mains. This time is required to allow for the
complete discharge of the electronic cir-
cuitry and thus preclude the possibility of
electric shock from the cable terminals.
Keep the Guarantee Certificate or the tech-
nical data sheet together with the instructions
manual throughout the product's service life.
These contain important technical information.
1 On/Off touch key.
2 Hotplate signaller and selection
touch keys.
3 Power and/or residual heat displays*.
4 Decimal point of the power and/or
residual heat indicators*.
5 Clock indicator.
6 “Minus” power time reduction touch key.
7 Clock touch key.
8 “Plus” power time increase touch key.
9 Locking touch key for the rest of the
touch keys.
10 Decimal point for the clock*.
11 Lock activated display*.
* Visible only when in use.
Ensure the appliance is installed by
an authorised person in accordance
with AS/NZS 3000.