OPERATING INSTRUCTIONS cont.
GETTING TO KNOW YOUR SHARK HAND VACUUM
Cleaning & Changing the
HEPA Dust Cup Filter
Warning:
Always unplug the unit from
electrical outlet before opening the Dust
Cup (container).
Important:
Do
NOT
use the HEPA filter
cartridge without the debris screen in
place.
Warning
:
After each Use - Always
remove the Filter Debris Screen from the
HEPA Dust Cup Filter, then vigorously
“
TapClean
” HEPA Filter until no more
dust can be removed.
Fig. 4
Fig. 3
Debris
Screen
HEPA Filter
PLEASE NOTE
: The white pleated
filter material in the HEPA Dust Cup
Filter will discolor over time -This is
NORMAL and will NOT affect the
performance of the filter. If the HEPA
Dust Cup Filter
is properly
"TapCleaned”
after each use
and suction
does not return
to 100%, then
we suggest that
the HEPA filter
be “TapCleaned”
vigorously until no
more dust can be removed, then
rinsed under the faucet and allowed to
dry for 24 hours before refitting into
the vacuum. (Fig. A) Wash once a
month or when suction appears
reduced.
5. Vigorously “TapClean”
the HEPA Dust Cup
Filter on a hard
surface until no more
dust is observed
falling out from
between the pleats of
the filter. (fig. 4)
Fig. 5
Debris
Screen
6. “TapClean” the Debris
Screen or rinse under
a faucet until clean.
(fig. 5) Remember that
the Debris Screen
must be completely
dry before reinstalling
in the vacuum.
7. Replace the Debris Screen on the
HEPA Dust Cup Filter and reinstall
filter assembly in the vacuum. (not
shown)
Fig. A
Wash once a
month or when
suction
appears
reduced.
Warning:
Allow 24
hours for drying before
replacing in unit.
HEPA Filter
Debris Screen
11
11
5
IMPORTANT, Please Note :
The
“TapClean” HEPA Dust Cup Filter &
Debris Screen will stop most of the tiniest
dust particles and airborne allergens from
re-entering the air you breathe. In fact it
stops 99.97% of all particles as small as
0.3 microns - many times smaller than a
human hair!!! Because of this incredible
filtration performance, the HEPA Dust Cup
Filter will quickly accumulate, inside the
white filter folds, many fine dust particles
that are difficult to see but which will
eventually block or reduce your suction
power - if not cleaned properly. Clean the
HEPA Filter and Debris Screen after each
use as described in this section.
1. To open the Dust Cup (container),
push button and detach the Dust
Cup (container ). (Fig. 1)
2. Pull out the HEPA Dust Cup Filter.
(Fig. 2)
Fig.2
Fig. 1
6.
Suction Hole
7.
Shoulder Strap
8.
Pet Hair Removal Attachment
9.
Cleaning Brush
10. Flexible Hose
11. Hepa Filter Assembly
1. Dust Cup Release Button
2. On/Off Power Switch
3. Handle
4. Intelli-Sense Filter Monitor
TM
5. Dust Cup (Container)
3. Empty the dust from the Dust Cup
(container).
4. Separate the debris screen from the
HEPA filter cartridge by grasping the
debris screen with one hand and the
filter frame with the other and pull
apart. (fig. 3)
Technical Specifications
Voltage:
120V., 60Hz.
Power:
6.67 Amps, 800 Watts
CAUTION
:
The suction hole must be
open, free of any obstructions at all
times. Otherwise, the motor will overheat
and could become damaged.
2
5
