Set Jumpers:
Jumpers are used to select the operation modes for your system. Some jumpers on
the board have three metal pins with each pin representing a different function.A
1 is written besides pin 1 on jumpers with three pins. To set a jumper, a black
cap containing metal contacts is placed over the jumper pin/s according to the
required configuration. A jumper is said to be shorted when the black cap has been
placed on one or two of its pins. The types of jumpers used in this manual are
shown below:
Note:
Users are not encouraged to change the jumper settings not listed in this manual.
Changing the jumper settings improperly may adversely affect system performance.
Open
Short
Jumper Cap
2-pin Jumper
3-pin Jumper
Jumper Block
1
2
3
1
2
3
Hardware Installation
2-2
