ETS SunStar 332, Руководство пользователя

Страница: 18 / 36

13
26868-01A
Installation - Remote Connections
Remote Connections
Your sunbed incorporates advanced cir-
cuitry allowing it to connect and com-
municate with most remote control sys-
tems. If a remote system is to be used,
first determine whether the remote sys-
tem is a T-Max® System or a standard
remote system operating with a control
relay. Follow the appropriate instructions
for your system type.
Two remote ports are located on top of
the ballast drawer at the front. Both ports
work the same. A Remote Control Bypass
plug is already installed in one of the
remote control ports. Your sunbed will not
operate without the Remote Control Bypass
plug or a remote system connected.
ATTENTION: Although the Remote
Control Bypass plug provided with your
sunbed will work wherever a T-Max® ter-
minator is called for in the series, the T-
Max® terminator will not work as a
bypass plug. Normally, a bypass plug is
needed only when your sunbed is operat-
ed without a remote system connected.
You will notice some wire clamps along
the side of the fan housing under the
bench. These are for the remote cables to
keep them out from under the ballast
drawer when rolling the drawer in and
out of the unit. Route the remote cables
as shown below, leaving some slack for
the drawer to roll out.
REAR
TO REMOTE
PORT
FAN HOUSING UNDER BENCH