ETS STARPOWER 548, Руководство пользователя

Страница: 20 / 40

15
27330-01A
Installation - Remote Connections
Scenario 1 - T-Max® Manager Series with wires
This system is ideal for multiple sunbed installa-
tions. Simply connect the RJ-22 modu-
lar cable(s), described in the T-Max®
Manager manual, into the remote
port(s) located on the ballast drawer and follow
the instructions that came with your remote
system. If you have an older T-Max® Manager
that does not support auto addressing, set
the address of each sunbed manually as
described in
Setting the address manually .
You can place your sunbed at any location in
the series.
Scenario 2 - Single Bed wired to T-Max® 3A
In single sunbed installations, the T-Max® 1A and
3A can offer the same control as the T-Max®
Manager, eliminating the need for a Manager. If
you’re using a 1A in this manner, it must have a
chip labelled “master” installed on its circuit
board. The remote control bypass plug must not be
used in this configuration. The 3A may be used as
a “master” with no modification.
NOTE: A T-Max® 1A with a
“master” chip can be substituted
for a 3A.
Scenario 3 - T-Max® Manager
Series with Complete Wireless
Connect one AP-900 Retail to the
Manager and one AP-900 OEM
to each of the tanning beds.
Install as many beds as you like
with this configuration. Units that
do not communicate with T-Max
will need an AP-900 Retail and
an additional 3A to operate.
After you have set the T-Max® 1A’s, or 3A’s, address
to “0” (refer to your T-Max® user’s guide) and the
sunbed’s address to “1”, simply connect the RJ-22
modular cables, described in the T-Max® user’s
guide, directly into either of the smaller ports locat-
ed on the ballast drawer and either port on the
back of the T-Max® 1A
or 3A.