8
3.8.3 RS-232 Baud Rate Setting
Press [
Menu]
button
until “Utility
Baud
” is shown on the LCD,
use the numeric buttons or rotary knob to modify
the corresponding code of baud rate to make sure that the baud rate meets the requirement of the PC remote
control.
The table below shows the corresponding code of baud rate.
Code
0
1
2
3
4
5
6
7
8
9
Baud rate
1200 2400
4800 9600
14400
19200
28800
38400
57600
115200
Setting method 1: Press
[numeric buttons 0-9] [Enter]
to set baud rate.
Setting method 2: Rotate the rotary knob choose a code.
3.8.4 Beeper Setting
Press [
Menu]
button
until “Utility Beep” is shown on the LC
D, then press
[
] [
]
or rotary knob to turn on or
off the beeper.
3.8.5 Hotkey Setting
Press key
[Menu]
until “Utility HotKey” is shown on the LCD
. Press
[
] [
]
or rotary knob
to turn on or off the
hotkey function. After the hotkey function is set ON, the numeric button 0 to 9 means the setting data of index
number 0 to 9 in memory bank. So the setting data of index number 0 to 9 can be recalled by pressing the
corresponding number.
3.8.6 Voltage Self-test Setting
Press
[Menu]
button
until “Utility
VselfTe
” is shown on the LCD
. Press
[
] [
]
or rotary knob
to turn on or off
the voltage self-test function. Users can enable this function to improve the voltage accuracy and get the accurate
setting voltage at the output terminal.
3.8.7 Save the Setting Data
The frequently used parameters can be stored into the 100 sets of Non-Volatile Memory in the power supply. User
